11
en
Operation
Once the target temperature is reached, the
lines go out and the next preparation time
is shown in the display. The preparation
process starts automatically. The
preparation time counts down.
Selecting a pre-configured
preparation time
The pre-configured preparation time of
the level [medium] is shown on the control
panel for each preparation programme.
The preparation time can be shortened
[short] or lengthened [long].
1.
Keep pressing button
E
until the
desired indicator is lit. The display
changes from [medium] to [long] and
then to [short ] before returning to
[medium].
The corresponding pre-configured values
for the preparation time are shown in the
display.
2.
Press button
G
to start the preparation
programme.
Extending the preparation time
during preparation
If the ingredients are not yet fully cooked
shortly before the end of a preparation
programme, the preparation time can be
extended.
1.
To do this, press and hold button
F
.
The current preparation time will be briefly
shown on the display and will then increase
in 1-minute increments.
2.
Press and hold the button until the
desired preparation time has been
reached.
3.
Activate the newly set preparation time
using button
G
.
Note:
The preparation time can only be
extended by a maximum of 30 minutes. If
the desired preparation time is exceeded,
hold button
F
until the maximum value is
reached. The setting will then jump back to
5 minutes.
Setting a start time delay
The start time delay can be set for the
selected preparation programme so you
can enjoy a freshly prepared meal at a
specific time.
Note:
The start time delay can only be
set for certain preparation programmes.
The pre-configured start time delay varies
among these preparation programmes.
1.
Select the preparation programme.
2.
Press button
A
. Button
G
flashes.
“00:10” flashes in the display.
Press button
A
repeatedly to increase the
displayed time. A brief press increases the
time by 5 minutes. A slightly longer press
increases the time by 10 minutes. Pressing
and holding button
A
for around 2 seconds
increases the time by 30 minutes.
3.
Press button
G
when the desired start
time delay is displayed.
The desired start time delay is shown in the
display. [timer] lights up in the display.
The time until the start counts down. Once
this time has elapsed, the preparation
process starts automatically.
Notes:
■ The start time delay can be switched
off at any time by pressing button
G
.
The preparation programme then starts
immediately.
■ If “00:10” does not flash in the display,
a start time delay cannot be set for the
selected preparation programme.
MUC2_MUC4_EU2.indb 11
15.03.2016 12:58:50
Содержание MUC22 Series
