MON152CL |
Instruction Manual
|
Installation
Bosch Security Systems | 22 September 2003
EN
| 10
10
b. Connect the other end of the extension cable (small
connector) to the power input connector on the rear
side of the LCD panel, as shown below in
Photo E
.
Photo E
3 Connect the appropriate ends of the IEC power cord to the
mains power source and power supply/base unit. Toggle the
power switch on the base to the ON position.
2.3.3
MON151PS Power Supply Installation
Use the MON151PS Power Supply (purchased separately) to
power the MON152CL unit's LCD panel separately from the
power supply/base unit. The mains power source (120/220
VAC), can be located at a distance of up to 3 m (10 ft) away.
Use for a wall mount or rack mount installation.
1. Follow the instructions in
Section 2.3.1
,
Step1
to remove
the power supply/base from the LCD panel section.
NOTE:
The power supply/base unit may now be stored, as
it is no longer required to power the unit.
2. Connect the bayonet connector from the power supply to
the power input connector on the rear side of the LCD
panel, as shown below in
Photo F
.
Photo F
3. Connect the IEC power cord to the MON151PS Power
Supply unit.
4. Mount the LCD panel in its intended location.
5. Connect the power end of the IEC power cord to the mains
supply source.
2.3.2
Extension Cable Installation
Use of the Extension Cable (included with the MON152CL)
allows the power supply/base unit to be located 1.5 m (5 ft) from
the LCD panel for wall mount or rack mount installations.
1. Follow the instructions in
Section 2.3.1, Step 1
to remove
the power supply/base from the LCD panel section.
2 Attach the Power Supply Extension Cable.
a. Connect one end of the extension cable (large
connector) to the power supply/base, as shown in
Photo D
, below.
Photo D
2. VESA standard mounting hole.
a. The square mounting hole patterns are VESA standard
on 100mm(3.9 in) centers, as show in below in
Photo C
. Mount the unit to mounting device using the
four mounting holes on the rear panel.
Photo C
b. Carefully remove the power bayonet connector
(
Fig. 4, item 9
) from the panel (see
Photo B
below),
while sliding off the base.
Photo B
