70
en | Using your MIC Camera
MIC IP fusion 9000i
2019-11 | 1.2 |
Operation Manual
Bosch Security Systems
11.3
Using the Wiper/Washer (Bosch Protocol)
The "predefined position" for the wash/wipe function is preset 62. The installer must define
preset 62 (preferably where the washer nozzle is located and can direct washer fluid towards
the camera window) before using the wiper/washer function.
To activate the washer/wiper function, press ON-105-ENTER and confirm this sequence:
1.
The wiper moves to a predefined position.
2.
The washer turns on for five seconds. Simultaneously, the wiper turns on and wipes five
times.
3.
The washer turns off. The wiper turns off.
4.
The camera returns to its previous PTZ position (and to inactive mode if applicable).
To activate the wiper manually (or if the corresponding alarm was activated or
deactivated):
Press
ON-102-ENTER
.
Note:
The wiper will turn off automatically after 5 minutes of use.
To activate intermittent wipe:
Press
ON-103-ENTER
. The wiper wipes twice, then returns to parked position, and then turns
off 15 seconds later.
To activate the wiper to wipe five (5) times:
Press
ON-104-ENTER
. The wiper wipes five times, then returns to parked position and turns
off.
Notice!
If the power fails while the wiper is activated, the wiper will return to parked position, after
power is restored, before turning off. The wiper will not stop in front of the camera window.
Содержание MIC IP fusion 9000i
Страница 1: ...MIC IP fusion 9000i en Operation Manual ...
Страница 2: ......
Страница 78: ...78 AUX Commands MIC IP fusion 9000i 2019 11 1 2 Operation Manual Bosch Security Systems ...
Страница 79: ......
