Bosch MIC 612 Series, Руководство по установке

Страница: 36 / 80

36 en | Getting Started MIC612 Thermal Camera
F.01U.249.416 | 2.0 | 2012.09 Installation Manual Bosch Security Systems, Inc.
5. Use the joystick to enter the unique identifier for the camera.
– Move the joystick up or down to select the number.
– Move the joystick right to move to the next number position.
6. Move the joystick right to select Continue. Then, press the FOCUS or the IRIS button.
7. Use the keyboard to enter the FastAddress number. Then, press the Camera button.
Note: To use a FastAddress number that is already assigned to a different camera, you
must clear the number first.
8. Move the joystick down then up again to set the FastAddress number.
9. Press the FOCUS or the IRIS button to store the FastAddress number.
The on-screen display menu confirms that the camera stored the FastAddress number.
5.4.4 Active Commands in FastAddress
The table below identifies the commands that will work and those that will not when users
send commands via the FastAddress of the thermal camera:
5.5 Setting Passwords
Passwords are used to control access to locked command menus. Unlocked commands are
available to all users. Passwords are four (4) digits in length.
5.5.1 Special Passwords
The table below identifies special passwords adn their function and security level.
5.5.2 Setting Passwords, Bosch Protocol
To set or change a password (locked command):
1. Press OFF-90-ENTER to turn off the command lock.
2. Press SET-802-ENTER to access the password menu.
3. Tilt the joystick up or down to choose a number. Tilt the joystick right to move to the next
number position.
4. Follow the on-screen instructions and save the password. You receive an on-screen
confirmation.
5.6 Configuring the Camera for Inverted Operation
The video display from a camera installed in inverted position will appear upside down until
you set the video orientation to “Inverted position.” Follow these steps:
1. Access the main Setup Menu of the on-screen display (OSD). The screen Setup Menu
appears.
2. Select the submenu “PTZ Setup.” The screen PTZ Setup appears.
3. Select the option “Orientation.”
4. Select the value “Inverted,” which rotates the video 180°. The video should now appear
upright.
Commands that will work Commands that will not work
Pan, tilt Menu commands
Thermal camera commands Visible camera commands
Certain Aux commands
(list to be populated)
Certain Aux commands
Password Function / Security Level
0000 (default) Enables security and requires a user to enter the unlock command
OFF-90-ENTER before invoking a locked command.
9999 Disables all security and allows all users to access locked commands.