Bosch MIC 612 Series, Руководство по установке

Страница: 33 / 80

MIC612 Thermal Camera Getting Started | en 33
Bosch Security Systems, Inc. Installation Manual F.01U.249.416 | 2.0 | 2012.09
5.3.5 Special Preset Commands, Pelco Protocol
Some Pelco mode preset commands have a special meaning and override the normal Pelco
preset function as follows:
5.4 Setting the Addresses of the Two Cameras of the MIC612
After the camera is on, you must set the camera address. The optical camera and the thermal
camera of the MIC612 have different addresses. The address of the optical camera is set via
the OSD and FastAddress. The address of the thermal camera is set via the OSD and a unique
address. From the factory, the default address of the optical camera is "0" and the default
address of the thermal camera is the address of the optical 1.
Keyboard Command User Action Description
0-Pattern Press Initiates recording continuous playback based upon
current Recording setting (A or B) in the Setup Menu.
Press and hold Initiates recording based upon current Recording
setting (A or B) in the Setup Menu. Press ACK to end
recording.
1-Pattern Press Initiate Recording A continuous playback.
Press and hold Initiate Recording A. Press ACK to end recording.
2-Pattern Press Initiate Recording B continuous playback.
Press and hold Initiate Recording B. Press ACK to end recording.
3-Pattern Press Initiate the MIC612 standard preset tour (Tour 1).
4-Pattern Press Initiate the MIC612 custom preset tour (Tour 2).
1 – Aux On / Aux Off Press Activates / deactivates alarm output 1.
This command is supported only if an 8-input alarm
card is installed in the PSU powering the camera.
2 – Aux On / Aux Off Press Activates / deactivates alarm output 2.
This command is supported only if an 8-input alarm
card is installed in the PSU powering the camera.
91 – Aux On Press Activate Zone Scan (display zone titles).
92 – Aux On Press Deactivate Zone Scan (re-move zone titles)
Preset Command Description
33-PRESET Pans the camera 180° (Flip).
34-PRESET Goes to Zero Pan (original home position).
81-PRESET Initiates Preset Tour 1 .
82-PRESET Initiates Preset Tour 2 .
92-PRESET Sets the Left pan limit for an AutoScan with Limit Stops enabled.
93-PRESET Sets the Right pan limit for an AutoScan with Limit Stops enabled.
94-PRESET Initiates a Preset Tour .
95-PRESET Enables or disables Limit Stops in the Setup Menu for AutoScan.
Invokes the Pelco main Setup Menu when pressed for 2 seconds.
96-PRESET Stops a scan.
97-PRESET Initiates FastAddress (Pelco Random Scan).
99-PRESET Starts an AutoScan.
NOTICE!
Some Pelco controllers do not support all of the preset command numbers. Consult the
documentation of the specific Pelco controller for supported preset commands.