Bosch MaxxiMUM MUMX50GXCN, Инструкция по эксплуатации

Страница: 22 / 37

22
en
Bowl and tools
■ Press release button and move
multi-function arm to position 2 .
■ Attach the cover.
■ Attach funnel (Fig.
F
-3) .
■ Insert the mains plug.
Note: When the whisk has been inserted,
the automatic SensorControl is initialised
and the symbols flash. The appliance is
ready to use when all 3 symbols are lit
evenly.
■ Put cream or egg whites in the bowl.
■ Processing quantities:
Whipped cream, 300-1500 ml
Best results are obtained with fresh
cream at 6 °C.
Egg whites: 2 to 12 x
■ Press the corresponding button on the
automatic SensorControl.
Whipped cream, initial quantity
300 to 700 ml
Whipped cream, initial quantity
700 to 1500 ml
Beaten egg white
The symbol of the selected automatic
SensorControl is lit, the other symbols go
out.
Correction if a wrong button was
selected: Press the relevant button.
■ Turn rotary switch to setting M/S and
hold for 2 seconds. When released, the
rotary switch stops in this position!
Note: If the rotary switch is not actu-
ated within 30 seconds, the selected
Sensor Control is deactivated!
All 3 symbols are lit again.
Correction if a wrong button was
selected:
■ Set rotary switch to 0 ; in doing so you
have to overcome a small resistance.
■ Press the relevant button.
■ Set rotary knob to setting M/S .
The appliance starts operating. As long as
the process is running, the buttons on the
SensorControl are locked.
Note: While the appliance is running, do not
add more ingredients!
When the whipped cream / egg whites have
reached the optimum consistency, the drive
automatically switches off.
The rotary switch moves to the 0 position.
The symbols are lit.
Important information:
The automatic SensorControl cannot
produce optimum results unless the eggs
are fresh or the cream has been cooled
(approx. 6 °C).
■ Cream which was previously frozen can
never be whipped.
■ Cream which contains additives or
lactose-free cream will not produce ideal
results.
■ Do not add sugar, flavours or other
additives until the automatic sequence
is complete. To do this, move the rotary
switch to setting 5.
■ If the result is not the one required
when the appliance has automatically
switched off, move the rotary switch to
setting 7 until the result is as expected.
Do not activate the automatic Sensor-
Control a second time!
■ The automatic SensorControl can be
interrupted at any time (rotary switch to
0 ; in doing so you have to overcome a
small resistance).
■ After a maximum of 6 minutes the drive
will always switch off, even if the defined
result was not obtained.
The symbols flash.
See “Troubleshooting”.
■ The automatic SensorControl has no
effect at settings 1-7 or when working
with the other drives.
■ If a button on the SensorControl is
accidentally pressed while working with
other accessories, simply press the
button again. The symbol goes out.
11_MUMX50GXCN_8001018585_02-ohneZubehör.indb 22 14.09.2015 12:37:39