Bosch IntuiKey Series, Руководство по установке

Страница: 19 / 32

IntuiKey Keyboard Installing the IntuiKey Keyboard | en 15
Bosch Security Systems, Inc. Installation Manual F.01U.115.018 | 1.92 | 2008.12
5. After a brief pause (or immediately after the CLR button is pressed) the keyboard
performs a brief search for connected devices.
3.3 KBD-Universal (RS-232 Protocol) Installation
The KBD-Universal keyboard can be connected to either an Allegiant LTC 8712 Series Console
Port Expander accessory unit, or the 9-pin Console or Printer (if equipped) RS-232 port on the
back of the Allegiant system. The keyboard may be connected via hardwired cable, dial-up
modem, or using another type of communication system conforming to standard RS-232
transmission.
For each keyboard being installed, a user-supplied 9-pin mating connector, and user-supplied
cable suitable for use with RS-232 signals is required.
Refer to the most applicable configuration diagram. See Figure 3.6 or Figure 3.7 .
3.3.1 Keyboard Number Assignments when Using RS-232 Model Keyboards
Use of RS-232 protocol keyboards does not increase the total number of keyboards that can
be connected to an Allegiant switcher. When an RS-232 keyboard is connected in the system,
a standard keyboard port will automatically become disabled. The disabled keyboard port
number will be based on the interface connection type of the RS-232 keyboard. Keeping track
of these keyboard numbers is necessary when priority-based restrictions, or other keyboard
related lockouts, are assigned and used in the system.
The table below indicates which keyboard number will be assigned, based on the connection
being used.
i
NOTICE! On initial power-up, factory reset, or firmware upgrade the IntuiKey displays the
Language menu. Select the desired language by pressing the softkey next to the language
title. If additional languages are available, the arrow softkeys at the bottom of the screen can
be used to scroll to a second menu screen.
i
NOTICE! To configure the IntuiKey to operate using Allegiant RS-232 protocol, enter the
Keyboard Control menu and press the protocol button. Enter the password (see APPENDIX A)
to change the protocol mode from RS-485 to RS-232.
Keyboard
Connection Type
Keyboard
Number
Direct to Console port 1
Direct to Printer port 5
Port 1 of Expander, when Expander is connected to Console port 1
Port 2 of Expander, when Expander is connected to Console port 2
Port 3 of Expander, when Expander is connected to Console port 3
Port 4 of Expander, when Expander is connected to Console port 4
Port 1 of Expander, when Expander is connected to Printer port 5
Port 2 of Expander, when Expander is connected to Printer port 6
Port 3 of Expander, when Expander is connected to Printer port 7
Port 4 of Expander, when Expander is connected to Printer port 8