Bosch HGA24W255I, Инструкция по эксплуатации

Страница: 16 / 28

16
7.
Close the oven door slowly.
8.
Preheat the empty oven for approximately 15 minutes before
baking.
9.
When the dish has finished cooking, turn off the switch for the
lower gas burner.
You can change the temperature at any time.
:
Caution:!
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
Procedure for setting the gas grill
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Turn on the main gas supply to the appliance. Connect the
plug to the socket.
3.
Insert the protecting plate into the groove under the control
panel.
The protecting plate is inserted with the longer edge facing
forwards and the curvature facing downwards.
Fasten the protecting plate in the groove under the control
panel using the retainers.
Make sure that the protecting plate is latched into the
retainers. Once the protecting plate cannot be removed, it is
correctly latched in place. You can now safely use the
protecting plate. If it can be removed, insert it into the groove
at a slightly higher angle and make sure that it latches into
the retainers.
4.
Close the oven door so that it is in contact with the protecting
plate.
5.
Press the function selector and turn it clockwise to the grill
setting ( .
6.
Keep the function selector pressed in and simultaneously
press the ignition button 8 .
7.
The gas leaving the gas grill is ignited using the ignition
button. To ensure that the ignition safety system responds,
press and hold the function selector for 10 seconds.
The ignition safety system is activated. If the gas flame goes
out, the gas supply is automatically interrupted by the ignition
safety system.
8.
Check whether the flame is lit. If the flame is not lit, repeat the
process from step 5.
9.
Once the meal is cooked, switch off the function selector.
Once the oven has cooled down, remove the protecting
plate.
:
Caution!
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.
Setting the timer
You can use the timer as a kitchen timer. It runs independently
of the oven. The timer has a special signal. This means that you
can tell whether the timer or cooking time has expired.
Setting procedure
1.
Press the 0 Clock button.
The S timer symbol flashes.
2.
Use the + or - button to set the timer time.
+ button / default value = 10 minutes
- button / default value = 5 minutes
The timer starts after a few seconds. The S symbol appears in
the display. The elapsed time is shown.
The time has elapsed
A signal sounds. Press the 0 Clock button. The timer display
goes out.
Changing the timer duration
Press the Clock button. Use the + or - button to change the
time.
Cancelling the setting
Press the 0 Clock button. Press the - button repeatedly until a
zero appears in the display.
The timer and cooking time count down at the same time
The symbols light up. You can see the timer time counting
down in the display.
To query the x remaining time:
Press the 0 button.
The queried value appears in the display for a few seconds.