Bosch HGA24W255I, Инструкция по эксплуатации

Страница: 13 / 28

13
Before using the oven for the first time
In this section, you can find out what you must do before using
your oven or gas hob to prepare food for the first time. First
read the section on Safety information .
Setting the time of day
When you connect the power for the first time, the x symbol
lights up.
1.
Make sure that the x is flashing in the display.
2.
Press the 0 button.
The display goes dark.
You can use the oven clock as a timer. How to set the timer is
explained on the following pages.
Caution!
The clock runs independently of the lower gas burner and gas
grill.
The oven clock can be used as a timer.
The clock runs independently of the oven.
The clock has no effect on the gas supply to the lower gas
burner and grill burner. The gas supply is interrupted if the
switch is turned off.
Heating up the oven
To remove the new cooker smell, heat up the oven when it is
empty and closed. Ensure that no packaging material has been
left in the cooking compartment.
Keep the kitchen ventilated the whole time the oven is on.
Setting procedure for the lower gas burner
Example in the picture: Heat at 270 °C
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Open the main gas supply to the appliance. Connect the plug
in the socket. Open the oven door.
3.
Push in the switch for the lower gas burner and turn it to
270 °C.
4.
While holding the switch for the oven's lower gas burner
depressed, press the ignition button 8 .
5.
The gas escaping from the oven's lower gas burner is ignited
using the ignition button. To activate the safety pilot, press
and hold the lower gas burner on the oven for 10 seconds.
6.
Look through the inspection port to make sure that the flame
is lit. If it is not, repeat the process from step 3.
7.
Close the oven door slowly.
8.
Turn off the switch for the lower gas burner after 30 minutes.
Procedure for setting the gas grill
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Turn on the main gas supply to the appliance. Connect the
plug to the socket.
3.
Insert the protecting plate into the groove under the control
panel.
The protecting plate is inserted with the longer edge facing
forwards and the curvature facing downwards.
Fasten the protecting plate in the groove under the control
panel using the retainers.
Make sure that the protecting plate is latched into the
retainers. Once the protecting plate cannot be removed, it is
correctly latched in place. You can now safely use the
protecting plate. If it can be removed, insert it into the groove
at a slightly higher angle and make sure that it latches into
the retainers.
4.
Close the oven door so that it is in contact with the protecting
plate.
5.
Press the function selector and turn it clockwise to the grill
setting ( .
6.
Keep the function selector pressed in and simultaneously
press the ignition button 8 .
7.
The gas leaving the gas grill is ignited using the ignition
button. To ensure that the ignition safety system responds,
press and hold the function selector for 10 seconds.
8.
Check whether the flame is lit. If the flame is not lit, repeat the
process from step 5.
9.
Switch off the function selector after 30 minutes. Once the
oven has cooled down, remove the protecting plate.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.
Cleaning the accessories
Before you use the accessories for the first time, clean them
thoroughly with hot soapy water and a soft dish cloth.