28
| English
1 609 929 T67 | (3.7.09)
Bosch Power Tools
a) Simple Pythagoras Measurement
(see figure H)
Press the function-mode button
3
until the in-
dication for simple Pythagoras measurement
appears on the display.
Measure distances
“1”
and
“2”
in this sequence
with a length measurement. Pay attention that a
right angle exists between distance
“1”
and the
sought distance
“E”
.
Upon completion of the last
measurement, the result for
the sought distance
“E”
is
displayed in the result line
c
.
The individual measured
values are displayed in the
measured-value lines
a
.
b) Double Pythagoras Measurement
(see figure I)
Press the function-mode button
3
until the indi-
cation for double Pythagoras measurement
appears on the display.
Measure distances
“1”
,
“2”
and
“3”
in this se-
quence with a length measurement. Pay atten-
tion that a right angle exists between distance
“1”
and the sought distance
“E”
.
Upon completion of the last
measurement, the result for
the sought distance
“E”
is
displayed in the result line
c
.
The individual measured
values are displayed in the
measured-value lines
a
.
c) Combined Pythagoras Measurement
(see figure J)
Press the function-mode button
3
until the in-
dication for combined Pythagoras measurement
appears on the display.
Measure distances
“1”
,
“2”
and
“3”
in this se-
quence with a length measurement. Pay atten-
tion that a right angle exists between distance
“1”
and the sought distance
“E”
.
Upon completion of the last
measurement, the result for
the sought distance
“E”
is
displayed in the result line
c
.
The individual measured
values are displayed in the
measured-value lines
a
.
d) Trapezium Measurement (see figure K)
Press the function-mode button
3
until the in-
dication for trapezium measurement appears
on the display.
Measure distances
“1”
,
“2”
and
“3”
in this
sequence with a length measurement. Pay at-
tention that the measurement of distance
“3”
starts exactly at the end point of distance
“1”
and that a right angle exists between distances
“1”
and
“2”
as well as between
“1”
and
“3”
.
Upon completion of the last
measurement, the result for
the sought distance
“E”
is
displayed in the result line
c
.
The individual measured
values are displayed in the
measured-value lines
a
.
Time-delayed Length Measurement
Time-delayed length measurement is helpful
e.g. when measuring at hard to reach locations
or when movements of the measuring tool
during measuring are to be prevented.
For a time-delayed length measurement, press
function-mode button
3
until the indicator for
time-delayed length measurement appears on
the display.
The time period from the actuation until the
measurement takes place is displayed in the
measured-value line
a
. The time period can be
adjusted between 1 s and 60 s by pressing the
plus button
6
or the minus button
12
.
Then press the measuring
button
7
to switch the laser
beam on and aim at the tar-
get point. Press the measur-
ing button
7
again to actuate
the measurement. The meas-
urement takes place after the
set time period. The measured value is dis-
played in the result line
c
.
The addition and subtraction of measuring re-
sults as well as minimum/maximum measure-
ments are not possible for time-delayed length
measurements.
1
2
1
3
2
1
3
2
1
3
2
