English |
47
Bosch Power Tools
1 609 929 W28 | (16/4/10)
Aligning the Angle Indicator (Vertically)
(see figure R)
– Bring the power tool into the working posi-
tion.
– Turn the saw table
8
to the 0° detent
14
. The
lever
12
must be felt to engage in the detent.
Checking:
The angle indicator
20
must be in alignment
with the 0° mark of the scale
19
.
Adjusting:
– Loosen the screw
56
with the Phillips screw-
driver provided and align the angle indicator
along the 0° mark.
– Afterwards, check to ensure that the adjust-
ment made is correct for the 45° mark.
– Retighten the screw again.
Aligning the Fence
– Bring the machine into the transport posi-
tion.
– Turn the saw table
8
to the 0° detent
14
. The
lever
12
must be felt to engage in the detent.
Checking:
(see figure S1)
– Set an angle gauge to 90° and place it on the
saw table
8
between the fence
18
and the
saw blade
40
.
The leg of the angle gauge must be flush with
the fence over the complete length.
Adjusting:
(see figure S2)
– Loosen all Allen screws
24
with the Allen key
26
provided.
– Turn the fence
18
until the angle gauge is
flush over the complete length.
– Retighten the screws again.
Setting the Standard Bevel Angle 0°
(Vertical)
– Bring the machine into the transport posi-
tion.
– Turn the saw table
8
to the 0° detent
14
. The
lever
12
must be felt to engage in the detent.
Checking:
(see figure T1)
– Set an angle gauge to 90° and place it on the
saw table
8
.
The leg of the angle gauge must be flush with
the saw blade
40
over the complete length.
Adjusting:
(see figure T2)
– Turn the Allen screw
57
in or out using a suit-
able Allen key (size 3 mm) until the leg of the
angle gauge is flush with the saw blade over
its complete length.
In case the angle indicator
20
is not in a line with
the 0° mark of the scale
19
after the adjust-
ment, the angle indicator must be aligned ac-
cordingly (see “Aligning the Angle Indicator
(Vertically)”, page 47).
Setting the Standard Bevel Angle 45°
(Vertical)
– Bring the power tool into the working posi-
tion.
– Turn the saw table
8
to the 0° detent
14
. The
lever
12
must be felt to engage in the detent.
– Loosen the clamping lever
21
and tilt the tool
arm leftward to the stop (45°) by the handle
5
.
Checking:
(see figure U1)
– Set an angle gauge to 45° and place it on the
saw table
8
.
The leg of the angle gauge must be flush with
the saw blade
40
over the complete length.
Adjusting:
(see figure U2)
– Turn the Allen screw
58
in or out using a suit-
able Allen key (size 3 mm) until the leg of the
angle gauge is flush with the saw blade over
its complete length.
In case the angle indicator
20
is not in a line with
the 45° mark of the scale
19
, firstly check the 0°
setting for the bevel angle and the angle indica-
tor again. Then repeat the adjustment of the 45°
bevel angle.
OBJ_BUCH-1168-001.book Page 47 Friday, April 16, 2010 5:25 PM
