English |
41
Bosch Power Tools
1 609 929 W28 | (16/4/10)
– Push the locking lever
35
and at the same
time move the tool arm by the handle
5
downward.
– Guide the tool arm downward until the trans-
port safety-lock
27
can be pushed complete-
ly inward.
Preparing for Operation
Clamping the Workpiece (see figure F)
To ensure optimum working safety, the work-
piece must always be firmly clamped.
Do not saw workpieces that are too small to
clamp.
– Press the workpiece firmly against the
fence
18
.
– Insert the material clamp
42
provided into
one of the holes
16
intended for it.
– Loosen the wing bolt
43
and adapt the mate-
rial clamp to the workpiece. Tighten the wing
bolt again.
– Firmly clamp the workpiece by turning the
threaded rod
44
in clockwise direction.
Adjusting the Cutting Angle
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use (see “Checking
and Adjusting the Basic Adjustment”, page 46).
f
Always tighten the locking knob 11 firmly
before sawing.
Otherwise the saw blade can
become wedged in the workpiece.
Adjusting Horizontal Mitre Angles
(see figure G)
The horizontal mitre angle can be set in the
range from 50° (left side) to 58° (right side).
– Loosen the locking knob
11
in case it is tight-
ened.
– Pull the lever
12
and turn the saw table
8
un-
til the desired mitre angle is indicated on the
angle indicator
13
.
– Tighten the locking knob
11
again.
For quick and precise setting of often used mi-
tre angles,
detents
14
are provided on the saw
table:
– Loosen the locking knob
11
in case it is tight-
ened.
– Pull lever
12
and rotate the saw table
8
left
or right to the requested detent.
– Release the lever again. The lever must be
felt to engage in the detent.
Adjusting Vertical Bevel Angles (see figure H)
The vertical bevel angle can be set in the range
from 0° to 45°.
– Loosen the clamping lever
21
.
– Tilt the tool arm by the handle
5
until the an-
gle indicator
20
indicates the desired bevel
angle.
– Hold the tool arm in this position and retight-
en the clamping lever
21
.
For quick and precise setting of the standard
angles 0° und 45°,
end stops are provided on
the housing.
– For this, tilt the tool arm by the handle
5
to
the stop toward the right (0°) or to the stop
toward the left (45°).
Starting Operation
Switching On (see figure I)
– For
starting operation
, pull the On/Off
switch
4
in the direction of the handle
5
.
Note:
For safety reasons, the On/Off switch
4
cannot be locked; it must remain pressed during
the entire operation.
The tool arm can be guided down only after
pushing the locking lever
35
.
– For
sawing
, the locking lever
35
must be
pushed in addition to pressing the On/Off
switch.
Left
Right
0°
15°; 22.5°;
30°; 45°
15°; 22.5°;
30°; 45°
OBJ_BUCH-1168-001.book Page 41 Friday, April 16, 2010 5:25 PM
