English |
43
Bosch Power Tools
1 609 929 X03 | (29/7/10)
Checking and Adjusting the Basic
Adjustment
f
Before any work on the machine itself, pull
the mains plug.
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use.
A certain level of experience and appropriate
specialty tools are required for this.
A Bosch after-sales service station will handle
this maintenance task quickly and reliably.
Setting the Standard Bevel Angle 0°
(Vertical)
– Bring the power tool into the working posi-
tion.
– Turn the saw table
17
to the 0° detent
16
.
The lever
14
must be felt to engage in the de-
tent.
Checking:
(see figure R1)
– Adjust an angle gauge to 90° and position it
on the saw table
17
.
The leg of the angle gauge must be flush with
the saw blade
7
over the complete length.
Adjusting:
(see figure R2)
– Loosen the clamping lever
32
.
– Loosen the locking nut of the stop bolt
24
with the open-ended spanner
35
(12 mm)
provided.
– Screw the stop screw in or out until the leg
of the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever
32
again.
– Afterwards, retighten the lock nut of the stop
screw
24
again.
When the angle indicator
48
is not in line with
the 0° mark of scale
54
after adjusting, loosen
screw
53
with the provided Phillips screwdriver
30
and align the angle indicator alongside the 0°
mark.
Setting the Standard Bevel Angle 45°
(Vertical)
– Bring the power tool into the working posi-
tion.
– Turn the saw table
17
to the 0° detent
16
.
The lever
14
must be felt to engage in the de-
tent.
– Loosen the clamping lever
32
and tilt the tool
arm leftward to the stop (45°) by the handle
6
.
Checking:
(see figure S1)
– Adjust an angle gauge to 45° and position it
on the saw table
17
.
The leg of the angle gauge must be flush with
the saw blade
7
over the complete length.
Adjusting:
(see figure S2)
– Loosen the locking nut of the stop bolt
23
with the open-ended spanner
35
(12 mm)
provided.
– Screw the stop screw in or out until the leg
of the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever
32
again.
– Afterwards, retighten the lock nut of the stop
screw
23
again.
In case the angle indicator
48
is not in a line with
the 45° mark of the scale
54
, firstly check the 0°
setting for the bevel angle and the angle indica-
tor again. Then repeat the adjustment of the 45°
bevel angle.
Aligning the Fence
– Bring the machine into the transport posi-
tion.
– Turn the saw table
17
to the 0° detent
16
.
The lever
14
must be felt to engage in the de-
tent.
Checking:
(see figure T1)
– Adjust an angle gauge to 90° and position it
between the fence
9
and the saw blade
7
on
the saw table
17
.
The leg of the angle gauge must be flush with
the fence over the complete length.
OBJ_BUCH-1126-002.book Page 43 Thursday, July 29, 2010 12:07 PM
