40
| English
1 609 929 X03 | (29/7/10)
Bosch Power Tools
Sawing
Sawing without Slide Movement (Cutting Off)
(see figure O)
– For cuts without slide movement (small
workpieces), loosen the locking screw
26
in
case it is tightened. Slide the tool arm to the
stop in the direction of the fence
9
and
retighten the locking screw
26
.
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Set the desired mitre angle.
– Switch on the machine.
– Push the locking lever
4
and guide the tool
arm slowly downward with the tool handle
6
.
– Saw through the workpiece applying uniform
feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Sawing with Slide Movement
– For cuts using the slide device
25
(wide
workpieces), loosen the locking screw
26
in
case it is tightened.
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Set the desired mitre angle.
– Pull the tool arm away from the fence
9
far
enough so that the saw blade is in front of
the workpiece.
– Switch on the machine.
– Push the locking lever
4
and guide the tool
arm slowly downward with the tool handle
6
.
– Press the tool arm in the direction of the
fence
9
and saw through the workpiece ap-
plying uniform feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Adjusting the Depth Stop (Sawing Grooves)
(see figure P)
The depth stop must be adjusted when a butt
gap is to be sawed.
– Loosen both lock nuts
50
using a commercial
box-end or open-end spanner (size 14 mm).
– Loosen the knurled nut
2
.
– Tilt the tool arm by the handle
6
to the posi-
tion at which the requested groove depth is
reached.
– Screw adjusting screw
34
in clockwise or an-
ticlockwise direction with an Allen key
(8 mm) until the screw end faces against the
depth stop
51
.
– Guide the tool arm slowly upward.
– First tighten the knurled nut
2
and then the
locking nuts
50
.
Sawing Workpieces of the Same Length
(see figure Q)
The length stop
52
can be used for easily sawing
workpieces to the same length.
– Move the length stop
52
on the extension bar
45
toward the saw blade to the desired clear-
ance.
Special Workpieces
When sawing curved or round workpieces,
these must be especially secured against slip-
ping. At the cutting line, no gap may exist be-
tween workpiece, fence and saw table.
Provide for special fixtures, if required.
OBJ_BUCH-1126-002.book Page 40 Thursday, July 29, 2010 12:07 PM
