DSA E-Series (E2700)
Turning on the power and checking for problems in an E2700 controller-drive tray configuration | en
69
Bosch Sicherheitssysteme GmbH
Installation manual
2015.10 | V2 | DOC
12.9
Things to know –seven segment display sequence code
definitions on the E2700 controller-drive tray
During normal operation, the tray ID display on each controller canister displays the
controller-drive tray ID. The Diagnostic LED (lower-digit decimal point) comes on when the
display is used for diagnostic codes and goes off when the display is used to show the tray ID.
The category code may be followed by a dash + and a "CF," followed by one of the component
location codes (see
Things to know –seven segment component failure identifications for the
E2700 controller-drive tray, page 69
).
Sequence code definitions for the E2700
Category
Category Code
(see
1
)
Detail Codes
(see
2
)
Startup error
SE+ (see
3
)
–
88+ Power-on default
–
dF+ Power-on diagnostic fault
–
Sx Power-on validation error
Operational error
OE+
Lx+ Lock-down codes.
Operational state
OS+
–
OL+ = Offline.
–
bb+ = Battery backup (operating on batteries).
–
OH + CPU temperature exceeds the warning level
–
CF+ = Component failure.
–
Sd+ = Start of Day (SOD) processing
Component failure
CF+
–
dx+ = Processor or cache DIMM.
–
Cx = Cache DIMM.
–
Px+ = Processor DIMM.
–
Hx+ = Host interface card.
–
Fx+ = Flash drive.
–
bl + Base ControllerCard
Diagnostic failure
dE+
Lx+ = Lock-down code.s (see
Things to Know – Lock-Down
Codes for the Controller-Drive Tray, page 70
and
Things to
know – seven-segment display use cases, page 72
)
Category delimiter
dash+
The separator between category-detail code pairs is used
when more than one category detail code pair exists in the
sequence.
End-of-sequence delimiter
blank - (See
4
)
The end-of-sequence delimiter is automatically inserted by
the hardware at the end of a code sequence.
1
A two-digit code that starts a dynamic display sequence.
2
A two-digit code that follows the category code with more specific information.
3
The plus (+) sign indicates that a two-digit code appears with the Diagnostic LED on.
4
No codes appear, and the Diagnostic LED is off.
12.10
Things to know –seven segment component failure
identifications for the E2700 controller-drive tray
Use the seven segment display values to identify component.
Содержание DSA E-Series (E2700)
Страница 1: ...DSA E Series E2700 DSA N2E7Xx xxAT DSX N1D6Xx 12AT DSX N6D6Xx 60AT en Installation manual ...
Страница 2: ......
Страница 78: ......
Страница 79: ......