Bosch DOK-MOTOR-MCL Series, Руководство по планированию проекта

Страница: 15 / 196

2 Important instructions on use
2.1 Appropriate use
2.1.1 Introduction
Bosch Rexroth products are designed and manufactured using the latest
state-of-the-art-technology. Before they are delivered, they are inspected to
ensure that they operate safely.
The products may only be used as intended. If they are not used as intended,
situations may arise which result in personal injuries and property damage.
For damage caused by products not being used as intended,
Bosch Rexroth gives no warranty, assumes no liability, and will
not pay for any damages. Any risks resulting from the products
not being used as intended are the sole responsibility of the user.
Before using Bosch Rexroth products, the following conditions must be fulfil‐
led so as to ensure that the products are used as intended:
●
Everyone who in any way whatsoever handles one of our products must
read and understand the corresponding notes regarding safety and re‐
garding the intended use.
● If the products are hardware, they must be kept in their original state,
i.e., no constructional modifications may be made. Software products
may not be decompiled, and their source codes may not be modified.
● Damaged or improperly working products may not be installed or put in‐
to operation.
● It must be ensured that the products are installed according to the regu‐
lations specified in the documentation.
2.1.2 Areas of use and application
Coreless linear motors MCL of the IndraDyn L series by Bosch Rexroth are
determined to be used as linear servo drive motors.
There are drive controllers with different ratings, different DC bus voltages
and different interfaces to allow application-specific use of the motors. To
control and monitor the motors, additional sensors must be connected, e.g.,
length measuring systems.
● The motors may only be used with the accessories specified
in this documentation. Components that are not explicitly
mentioned may neither be attached nor connected. The
same is true for cables and lines.
● The motors may only be operated in the explicitly mentioned
configurations and combinations of components and with the
software and firmware specified in the corresponding func‐
tional description.
Any connected drive controller must be programmed before startup in order
to ensure that the motor executes the functions specifically to the particular
application.
The motors may only be operated under the assembly, mounting and installa‐
tion conditions, in the normal position, and under the environmental condi‐
tions (temperature, degree of protection, humidity, EMC, etc.) specified in this
documentation.
DOK-MOTOR*-MCL********-PR05-EN-P Bosch Rexroth AG 13/193
Rexroth IndraDyn L Ironless Linear Motors MCL
Important instructions on use