12
Installation
This extractor hood
is intended to be
mounted onto the kitchen wall.
1.
Remove the grease filter
(refer to Operating Instructions).
2.
Draw a line on the wall from the ceiling
to the lower edge of the hood at the
centre of the location where the hood is
going to be mounted.
3.
Use the template to mark the points on
the wall where the screws will be
mounted. In order to make it easier to
hook the hood onto the screws, draw
the outline of the area where the hood
will be attached.
Ensure that the minimum distance bet-
ween the hob and the extractor hood is
maintained –
550 mm
for an electric hob
and
650 mm
for a gas hob. The bottom
edge of the template equates to the lower
edge of the extractor hood.
4.
Drill 4 x
l
8 mm holes for the extractor
hood and 2 x
l
8 mm holes for the
chimney panelling. Insert plugs into the
holes so that they are flush with the wall.
23
172
455
68
150
mind.550 Elektro
mind.650 Gas
216
7.
Attach the extractor hood.
Adjust the height and align horizontally
with the adjusting screws.
The glass screen must not touch the
wall.
Note:
Take into account any special
accessories that are going to be fitted.
5.
Attach the 2 enclosed spacers to the
fixing bracket for the flue duct panelling.
6.
Screw on the upper and the two lower
fixing brackets.
Содержание DKE 66 . .
Страница 2: ...2 mind 650 mind 550 Abb 1 ELECTRO Fig 1 GAZ ...
Страница 14: ...14 Notes ...
Страница 15: ...15 360732 DHZ 5185 1 2 3 4 5 6 2x 10x 2x ...
Страница 16: ...5750 207 133 Printed in Germany 0904 Es Robert Bosch Hausgeräte GmbH ...