Bosch DIP-5042EZ-0HD, Руководство по установке

Страница: 29 / 46

DIVAR IP 5000 Maintaining the system | en 29
Bosch Sicherheitssysteme GmbH 2016.03 | V1 | DOC
To replace hard disks:
1. Remove the defective hard disk. Use the handle to pull the
disk carrier out of the chassis.
Note: You can remove the hard disk during operation.
2. Turn off the unit by pressing the power button.
3. Insert the new hard disks into the chassis bay, making sure
that the drive carrier handle is completely closed.
4. Turn on the unit by pressing the power button.
5. Open DIVAR IP Dashboard with any browser. To do this, in
the address bar of the web browser, enter
http://
mydivar/dlacockpit
or
http://<IP address of DIVAR
IP>/dlacockpit
, then press ENTER. DIVAR IP 5000
Dashboard displays the message that you must open
Configuration > Disk management for configuration.
6. Click Configuration to open the configuration.
7. Expand System , then click Disk management .
8. To add the storage capacity of the hard disks to the system,
follow the instructions that are displayed.
9. After finishing the hard disk setup the individual disk status
LED to the right of the disk carrier will turn blue.
See also:
– Chassis setup
9.5 Updating the system
Following procedure describes how to update the system
manually.
To update DIVAR IP manually:
1. In DIVAR IP Dashboard, click Device monitor in the tree
structure.
2. Click Update manually .
A dialog box is displayed where you can browse for the
update file.