Bosch DIP-5042EZ-0HD, Руководство по установке

Страница: 19 / 46

DIVAR IP 5000 Installation - first steps | en 19
Bosch Sicherheitssysteme GmbH 2016.03 | V1 | DOC
5 Installation - first steps
DIVAR IP systems are shipped with a pre-installed browser-
based configuration wizard.
5.1 Setup notes
By default all DIVAR IP systems are configured to obtain a valid
network address from DHCP server in the local network. In
small networks this task is usually performed by an internet
router. If there is no DHCP server in the network, DIVAR IP will
use the following network settings:
–
IP Address: 192.168.0.200
– Subnet mask: 255.255.255.0
Notice!
We strongly recommend that you do not change any operating
system settings. Operating system access should only be used
for troubleshooting. Changes can result in malfunctioning of the
system.
5.2 Connecting the unit
DIVAR IP system is ready to go out of the box. The application
provides a simple to install and intuitive to use solution for
network surveillance systems.
Connecting the unit:
1. Connect the unit and the cameras to the network.
2. Connect the unit to the power supply.
3. Turn on the unit.
Note: During this initial setup the system LED is blinking.
After the system is ready for operation, the system LED
stops blinking. The web based wizard pages of the DIVAR IP
can be accessed from any browser within the network. Use
these web page wizard pages to obtain a basic system
configuration.