-11-
GEAR SHIFTING
Your tool is equipped with two separate gear
ranges, low gear 1 and high gear 2. Low gear
provides high-torque and slower drilling
speeds for heavy duty work or for driving
screws. High gear provides faster speeds for
drilling lighter work. To change speeds slide
switch, to the high 2 or low position 1 (Fig. 7).
ATTENTION:
If your tool appears to be
running, but the chuck will not turn, check to
make sure the gear shifter is pushed fully into
desired setting.
GEAR
SHIFTER
FIG. 7
MODE SELECTOR SWITCH
The mode selector switch allows the tool to
be set for various drilling or driving
applications. Turn the mode selector switch
right or left depending on the below
applications (Fig. 8).
Drill only action: This mode will lock up
the clutch to permit drilling and driving
heavy duty work, and also will enable
bits to be changed quickly and easily in
the keyless chuck
Driver mode: To drive screws, nuts,
and bolts with use of the adjustable
clutch settings.
Drill with hammer action (
HDH183
Model only
): For drilling in
concrete, asphalt, tile or other similar
hard materials. The hammer drill
position overrides the clutch for
drilling.
ADJUSTABLE CLUTCH
Your tool features 25 clutch settings. Output
torque will increase as the clutch ring, is
rotated from 1 to 25. The tool will stop rotating
as soon as the set torque is reached during
operation (Fig. 9).
BRAKE
When the trigger switch is released it
activates the brake to stop the chuck quickly.
This is especially useful in the repetitive
driving and removal of screws.
BUILT IN WORK LIGHT
Your tool is also equipped with a light that turns
on automatically when the switch is activated,
for better visibility when drilling/driving (Fig. 1).
ADJUSTABLE
CLUTCH
FIG. 9
FIG. 8
MODE
SELECTOR
SWITCH
2610042685 DDH183 HDH183.qxp_DDH - HDH 1/22/16 12:26 PM Page 11
