Explanation of symbols and safety instructions
3
Compress 7001i/7400i AW AWE – 6721835320 (2021/09)
1
Explanation of symbols and safety instructions
1.1
Explanation of symbols
Warnings
In warnings, signal words at the beginning of a warning are used to
indicate the type and seriousness of the ensuing risk if measures for
minimizing danger are not taken.
The following signal words are defined and can be used in this document:
DANGER
DANGER
indicates that severe or life-threatening personal injury will
occur.
WARNING
WARNING
indicates that severe to life-threatening personal injury may
occur.
CAUTION
CAUTION
indicates that minor to medium personal injury may occur.
NOTICE
NOTICE
indicates that material damage may occur.
Important information
The info symbol indicates important information where there is no risk to
people or property.
Additional symbols
Table 1
1.2
General safety instructions
1.2.1
Application area
The heat pump may only be used in sealed heating systems according to
EN 12828.
Other uses are not appropriate. Any damage that results from such use is
excluded from liability.
The heat pump must undergo maintenance according to EN1717 4.6.
H
Safety of electrical devices for domestic use
and similar purposes
The following requirements apply in accordance with
EN 60335-1 in order to prevent hazards from
occurring when using electrical appliances:
“This appliance can be used by children of 8 years and
older, as well as by people with reduced physical,
sensory or mental capabilities or lacking in experience
and knowledge, if they are supervised and have been
given instruction in the safe use of the appliance and
understand the resulting dangers. Children shall not
play with the appliance. Cleaning and user
maintenance must not be performed by children
without supervision.”
“If the power cable is damaged, it must be replaced by
the manufacturer, its customer service department or
a similarly qualified person, so that risks are avoided.”
H
Inspection and maintenance
Regular inspection and maintenance are prerequisites
for safe and energy efficient operation of the heating
system.
We recommend you enter into a contract for the
annual inspection and demand-dependent
maintenance with an authorised installer.
▶ Have work carried out only by an approved installer.
▶ If any faults are discovered, have them remedied
immediately.
H
Inspection and maintenance
If there is a lack of cleaning, inspection or
maintenance, or if these are carried out incorrectly,
this may result in material damage and/or personal
injury, including possible risk to life.
▶ Have work carried out only by an approved
contractor.
▶ Do not take off the heat pump cover.
▶ Do not modify the heat pump or other parts of the
heating system.
H
Room air
The air in the installation room must be free of
combustible or chemically aggressive substances.
▶ Do not use or store combustible or explosive
materials (paper, propellants, thinners, paints,
etc.) within the vicinity of the appliance.
▶ Do not use or store corrosive substances (solvents,
adhesives, chlorinated cleaning agents, etc.) within
the vicinity of the appliance.
H
Damage caused by frost
The solar system can freeze if it is switched off:
▶ Observe the notices regarding frost protection.
▶ Due to the additional functions, e.g. DHW heating or
pump anti-seizure protection, the system should
always be left on.
▶ Correct any faults immediately.
H
Risk of scalding at the DHW draw-off points
▶ If DHW temperatures above 60 °C are set or if
thermal disinfection is activated, a mixer must be
installed. If in doubt, ask your installer.
Symbol
Meaning
▶
a step in an action sequence
a reference to a related part in the document
•
a list entry
–
a list entry (second level)
