Bosch CompactPower MFW3 Series, Инструкция по эксплуатации

Страница: 17 / 70

17
en Before using for the first time
Before using for the first
time
Before the new appliance can be used,
it must be fully unpacked, cleaned and
checked.
Caution!
Never operate a damaged appliance!
■ Remove the base unit and all
accessories from the packaging.
■ Remove the packaging material that is
present.
■ Dismantle any assembled parts into
their individual parts. Do this in reverse
order, as described under „Preparation“.
■ Check all parts for completeness.
X Fig.
A
/
B
■ Inspect all parts for visible damage.
■ Thoroughly clean and dry all parts
before using for the first time.
X “Care and daily cleaning” see
page 19
Control and display elements
Button ä
Press button ä to switch on the appliance.
The drive will start up at once.
Button ö
Press button ö to switch off the appliance.
The drive stops.
Operation indicator
The operation indicator lights up when the
appliance is switched on.
Release button
Press the release button to unlock an
attachment fitted on the appliance. Only
when the release button is pressed is it
possible to turn the attachment clockwise
and remove it from the base unit.
Cable storage compartment
The mains cable can be pulled out of the
cable storage compartment or pushed back
in again. Only ever pull the cable out as
much as is required.
Storage compartment
Unused perforated discs belonging to the
meat mincer can be kept in the storage
compartment and it closed with the cover.
Overload protection
To prevent serious damage to your
appliance if the base attachment is
overloaded, the agitator paddle has a
notch (predetermined breaking point).
If overloading occurs, the agitator paddle
will break at this point. A new agitator
paddle is available from Customer
Service (No. 630701). Spare parts with
a predetermined breaking point are not
covered by our warranty obligations.
Replace agitator paddle
X Fig.
C
1. Release the screw in the agitator paddle
with a screwdriver (PH2) and remove
the faulty paddle.
2.
Fit a new agitator paddle and screw tight
again.
Base unit
Preparation
W Risk of injury!
Do not insert the mains plug until all
preparations for working with the appliance
are complete and the required attachments
are assembled correctly and connected to
the base unit.
■ Place the base unit on a stable and level
work surface.
■ Pull the mains cable out of the cable
storage compartment to the required
length.
The base unit is now prepared.