Bosch BULLS Twenty 6 EVO, Перевод оригинальной инструкции по эксплуатации, Страница: 78 / 116

MY20B01 - 52_1.0_02.10.2019
78
Operation
Use of the hub gear is described in Figure 83:.
 Turn the twist grip (1) backwards to switch up
a gear (4).

Turn the twist grip (1) forwards to switch down
a gear (3).
 The gear shift switches the gear.
 The screen display (2) shows the changed
gear.
Figure 83: Example: use of Shimano Nexus gear shift
6.17.3 Using eShift
Only applies to pedelecs with this equipment
eShift refers to the integration of electronic gear
shift systems into the electric drive system.
6.17.3.1 eShift with Shimano DI2 automatic
hub gears
Only applies to pedelecs with this equipment
The automatic Shimano DI2 hub gear can be used
in manual or automatic mode. Use the shifter to
change gears in manual mode. In automatic
mode, the shift system changes gear
automatically depending on the speed, pedalling
power and pedalling frequency. You will find how
to switch from automatic to manual mode,
depending on the shifter used, described in your
operating instructions on the display screen. If you
use the shifter when in automatic mode, the gear
system will change to the next gear and it will
remain in automatic mode. Manual gear changes
in automatic mode influence shift behaviour in the
gear system and adjust gear changes to riding
performance. If the system is switched on for the
first time when a new, unused wheel is used, the
system will learn the gears first. To do so, the
automatic system changes to the highest/most
difficult gear and then switches through all gears
during the first ride. The new gear is shown briefly
on the display screen each time it is changed.
Since the drive unit detects the gear shift and
consequently reduces motor assistance briefly, it
is possible to switch gears under load or on hills.
If the pedelec is brought to a halt from a speed
greater than 10 km/h, the system can
automatically switch back to a pre-set START
GEAR.
 Set the START GEAR in the system settings
if necessary.
Notice
The interior hub is not completely waterproof. If
water gets into the hub, it may rust and the gear
switch function may no longer function as a result.
 Never use the pedelec in places where water
may get into the hub.
In rare cases, noises may be heard from the rear
derailleur in the hub interior after a gear change.
This is normal when gears are changed.
 Never detach the hub yourself. Contact your
specialist dealer.
1
2
3
4