Bosch BULLS Twenty 6 EVO, Перевод оригинальной инструкции по эксплуатации, Страница: 66 / 116

MY20B01 - 52_1.0_02.10.2019
66
Operation
1 Open battery lock with battery key (see [1]).

The battery is released and falls into the
retainer guard (see [2]).
2 Hold the battery in your hand from below. Use
the other hand to push on the retainer guard
from above (see [3]).
 The battery is released and falls into the hand
(see [4]).
3 Remove the battery from the frame.
4 Remove the battery key from the battery lock.
6.11.3.2 Inserting the integrated battery
Figure 70: Inserting the integrated battery
1 Place the battery into the lower mount with the
contacts facing the front (see [1]).
2 Flip the battery up so that the battery is held by
the retainer guard (see [2]).
3 Push the battery upwards (see [3]).
 There is an audible clicking noise.
4 Check battery to ensure it is firmly in place.
5 Lock the battery with the battery key;
otherwise, the battery may fall out of the mount
when you open the lock (see [4]).
6 Remove the battery key from the battery lock.
7 Check the battery to ensure it is firmly in place.
6.11.4 Charging the battery

The ambient temperature during the charging
process must be within the range from 0 °C to
40 °C.

The battery can remain on the pedelec or can be
removed for charging.

Interrupting the charging process does not
damage the battery.
1 Remove the cable connection cover if
necessary.
2 Connect the mains plug of the charger to a
normal domestic, grounded socket.
(1)
(2)
(3)
(4)
Fire caused by overheated charger
The charger heats up when charging the battery. In
case of insufficient cooling, this can result in fire or
burns to the hands.

Never use the charger on a highly flammable
surface (e.g. paper, carpet etc.).
 Never cover the charger during the charging
process.

Never leave battery unattended during charging.
Electric shock caused by penetration by water
If water penetrates into the charger, there is a risk of
electric shock.
 Never charge the battery outdoors.
Electric shock in case of damage
Damaged chargers, cables and plug connectors
increase the risk of electric shock.

Check the charger, cable and plug connector
before each use. Never use a damaged charger.
Notice
If an error occurs during the charging process, a
system message is displayed.
 Remove the charger and battery from
operation immediately and follow the
instructions.
Connection data 230 V, 50 Hz
CAUTION
!