EN
© 2005 Bosch Security Systems
Page 12 of 40
2.3
Attach the dome window to the camera module, aligning
the blue LOCK labels.
Snap the dome cover into position by pressing
gently on the dome 90° from the blue labels.
Photo 2C Attach dome window
2.4
While holding the top of the camera, rotate the lower
portion and align the camera dome yellow markers.
Photo 2D Align yellow markers
2.5
With the red dot on the camera module facing the red
dot on the backbox, slide the camera module into the
backbox module using the guides. Note that the camera is
shown turned 180 degrees to illustrate red markers.
Photo 2E Align red markers
2.6
While grasping the unit by the dome window, insert the
camera module completely into the backbox.
Photo 2F Insert camera module
2.7
While pressing up, twist the dome window/locking ring
clockwise approximately 1/4 turn. The camera will
initialize ten seconds after it is properly installed.
Photo 2G Lock dome into place
2.8
An optional tamper clip is provided to prevent the dome
from being removed. To install, locate the blue label,
orient the tamper clip with the two tabs pointing up, and
press the tamper clip into the locking ring just to the
right of either blue label. A straight blade screwdriver
will help push the clip in place.
Section 2
BLUE
LABEL
90°
90°
YELLOW
MARKERS
RED
MARKERS
RED DOTS
FACING
EACH
OTHER
TURN TO
LOCK
