Bosch 21-17-3234, Перевод оригинальной инструкции по эксплуатации

Страница: 102 / 262

MY22Z01 - 12_1.0_25.07.2022
101
Operation
6.5.5 Stem
6.5.5.1 Replacing the handlebars
Not included in price
6.5.5.2 Adjusting the handlebar height with
quick release
Only applies to pedelecs with this equipment
1 Open the stem clamping lever.
Figure 116: Open (2) and closed (1) stem clamping lever;
All Up used as an example
Figure 117: Pulling the locking lever upwards; All Up used
as an example
2 Pull out the handlebars to the required height.
Observe minimum insertion depth.
3 Close the stem clamping lever.
6.5.5.3 Checking the stem stability
 Hold handlebars firmly after adjusting the
saddle. Press full body weight on the
handlebars.
 The handlebars remain stable in their position.
6.5.5.4 Adjusting the quick release clamping
force
If the handlebar clamping lever stops before
reaching its end position, unscrew the knurled nut .

Tighten the knurled nut on the seat post if the
seat post clamping lever's clamping force is not
effective enough.
 Contact your specialist dealer if the clamping
force cannot be set.
Handlebar-stem units are components that may
be replaced after approval by the vehicle or parts
manufacturer. A stem must be replaced if cable
and/or line lengths do not need to be changed. A
change in riding position is allowed within the
original cable length. Furthermore, the load
distribution on the pedelec changes considerably
and may potentially lead to critical steering
performance
§
1
2
Crash caused by incorrectly set clamping
force
Applying excessive clamping force damages the
quick release. Insufficient clamping force will
result in unfavourable transmission of force. This
can cause components to break. This will cause a
crash with injuries.
 Never fasten a quick release using a tool (e.g.
hammer or pliers).
CAUTION
!