3 608 870 F34/2017-05 | IMenip2
Bosch Rexroth AG
21/28
ENGLISH
ENGL
IS
H
1. Always switch off the power supply to the
relevant system component before
assembling the IMenip2 interface
module.
2. Insert the IMenip2 interface module into
the appropriate slot on the system
component until it catches (example in
Fig. 2).
3. Tighten the torx screws on the front until
the front panel is flush. The circuit board
is locked by turning the screw.
Recommended screw tightening torque:
0.25 Nm
This lock is only fully functional once the
interface has been properly tightened
(see Fig. 3).
Fig. 2: Example: Inserting the interface module
Fig. 3: Lock effect
1
Lock
1
IMenip2_multi.book Seite 21 Mittwoch, 13. September 2017 8:33 08
