Bort 98292817, Руководство пользователя, Страница: 8 / 31

9
2. Pull up the knob of the fi lter frame, and pull out
the sponge fi lter and HEPA fi lter from the case box.
Cleaning the Sponge and HEPA fi lter by soft brush or
rinse it in lukewarm water and dry them completely
before use again. All the
fi lters are washable. ( we
recommend you to clean the fi lters when feeling the
suction power becoming weak.)
dust will full down automatically. Usually you may only
do like this to drop the dust.
3. If
fi nd the plastic centre system too dirty, please
press the dust cup cover release button, take out the
fi lter assembly out of the dust cup, then you can clean
them with soft brush or wash them with water. You
should dry them completely before you use again.
2. Install dust cup on the body:
1. Pull the dust cup bottom back to the dust cup until
the button be locked.
2. Put the dust cup onto the body case properly.
3. Push on the dust cup to
fi x with body.
4. Change or cleaning the inlet and exhaust HEPA fi lter
1. Push the dust cup release button, handing the dust
cup handle to rear side, take off the dust cup from the
vacuum cleaner. Draw out the inlet sponge and HEPA
fi lter set (Note: Please draw out the whole set with case
box.).
Fault Treatment
The cleaner cannot operate. 1. Check whether the power plug is
inserted securely; pull out the plug and
then reinsert it in the power socket;
2. Check whether the power socket is
electrified;
3. Check whether the switch of the cleaner
is in “ON” position.
The suction force is reduced. 1. Check whether the floor brush, the hose
and the spile are jammed, and remove any
blockage immediately;
2. Check whether the air-inlet filter gauze
is dusty; frequently clean rubbish or
replace air-inlet and air-outlet HEPA;
There is abnormal sound when the motor
is under operation. 1. Stop the cleaner immediately;
Check whether the floor brush, the hose
and the spile are jammed, and remove any
blockage immediately.