BorMann BPT1250, Руководство пользователя, Страница: 20 / 22

10
Take up a working position so that you are always on one side of the machine away from the area directly in
front of or behind the cutterhead. Place both hands on the workpiece with the fingers. Do not hold on to the
workpiece edges.
Only workpieces should be planed which rest firmly on the machine and can be safety guided.
Refer to figure 10.
Figure 10
THICKNESSING
-Set the desired height with handle assembly at spindle with reference to scale.
1 turn =3mm
-Slide in narrow wood in the middle.
When thicknessing the table must be lubricated regularly with lubricant. After having worked for a long
period or when planing wet wood it may occur that the workpiece stops while pulling in.
WARNING : Switch off the machine immediately in case of failure. Do not remove chips and splinters from
the tables while the machine is running.
Short workpieces should not be planed.
REPLACING BLADES
Disconnect machine from power before servicing!
Replacing blades
-Unplug the planer-thicknesser from power source and turn the switch to “off” position.
-Block the blade guard from closing down.
-Loosen and remove three blade lock screws securing blade and blade clamp.
-Lift blade and blade clamp from cutterhead.
-Clean any sawdust and resin buildup from cutterhead and blade clamp.
-Place blade clamp against the replacement blade and replace in cutterhead.
-Secure blade and blade clamp using three blade lock screws. Do not over-tighten blade lock screws first.
Note : Check blade height at both of blade
-Tighten blade lock screws.
-Recheck blade adjustment and make sure blade is still level with outfeed table.
-Repeat the procedure to replace the other blade.
-Remove the scrap wood and release blade guard.
-Make sure all the blade lock screws are tight and snug.
NOTE :
-The blades which used with the tool may be replaced or re-sharpened.
-If the blades are re-sharpened, the re-sharpenings should be not more than 3 times with 0.05mm max.
each time.
-the blades used in this tool can not be used to rebate
.