BorMann BPT1250, Руководство пользователя, Страница: 18 / 22

8
OPERATION REGULATIONS
ATTENTION: Make sure that the switch is in off position before adjusting the cutting depth, replacing or
adjusting the blades. Make sure the blade screws are securely tightened.
SETTING ANGLE FENCE
Insert screw into the slot A and B. Then loosen C to adjust angle fence.
Turn M down, guide fence may move to left or right.
Refer to figure 5
M
A C
B
Figure 5
OVERLOAD PROTECTION
If the motor protection responds, this always indicates that the motor is overloaded. The cause must be
located and the fault eliminated.
If the motor is overloaded or in the event of power failure, the motor switches off automatically. The
machine can not be switched on again until the motor is cooled down or the power supply has been
restored.
CHIP EXTRACTION
To ensure trouble free and reliable operation on enclosed premises, the machine must be connected to an
extractor unit at the dust chute E (accessory)
DUST CHUTE CONNECTION WHEN PLANING :
- Lift up the blade guard arm F so that the longitude holes G being exposed;
- Pull out the key H on both sides of the dust chute E;
- Move down the thickness table to the lowest position, and insert the dust chute E;
F
H
E
G