BorMann 036432, Руководство пользователя

Страница: 14 / 28

EN
WWW.BORMANNTOOLS.COM
14
Troubleshooting
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do not attempt to dismantle the tool.
Instead, seek help in an Authorized Service Centers, always using apropriate replacement parts for repairs (Bormann replacement parts).
Malfunction status Cause Action
The chain saw does not start Two battery cartridges are not installed Install two charged battery cartridges.
Battery problem (low voltage). Recharge the battery cartridges. If recharging is not effective, replace the
battery cartridge.
Main power switch is off. The chain saw is automatically turned off if it is unoperated for a certain
period. Turn on the main power switch again.
The saw chain does not run. Chain brake activated. Release chain brake.
The motor stops running after a
little use. Battery's charge level is low. Recharge the battery cartridges. If recharging is not effective, replace the
battery cartridge.
No oil on the chain. Oil tank is empty. Fill the oil tank.
Oil guide groove is dirty. Clean the groove.
Poor oil delivery Adjust the amount of oil delivery with the
adjusting screw.
The chain saw does not reach
maximum RPM. Battery cartridge is installed improperly. Install the battery cartridges as described in this manual.
Battery power is dropping. Recharge the battery cartridges. If recharging is not effective, replace the
battery cartridge.
The drive system does not work correctly.
Ask the authorized service center in your Ask the authorized service center in your region for repair.
Chain does not stop even the if
chain brake is activated:
Stop the machine immediately!
The brake band is worn down. Ask the authorized service center in your region for repair.
Abnormal vibration:
Stop the machine immediately!
Loose guide bar or saw chain. Adjust the guide bar and saw chain tension.
Tool malfunction. Ask the authorized service center in your region for repair.