BorMann 022947, Руководство пользователя

Страница: 32 / 38

19
www.BormannTools.com
Low table set up (Fig. 19)
1. The feet can be bolded as shown in the figure. To fold down the tool, do as follows_
2. Fall down the tool carefully BACKWARDS without tail while holding it with both hands.
3. Pull up first the stopper at the joint of left lest toward yourself to unlock it
4. Take the same steps for the opposite feat as above.
5. Use a hook to bundle these feet.
6. Return the tool to the upright position.
Installing or removing saw blade
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing the blade.
• Use only the socket wrench provided to install or remove the blade. Failure to do so may result in over• tightening or insufficient
tightening of the hex bolt. This could cause an Injury.
Move up the handle in the fully raised position.
Press the shaft lock to lock the spindle, use the socket wrench to loosen the hex bolt clockwise. (Fig. 20)
Raise the blade guard A with its lifting lever while pushing the lever nearby the handle to the left. With the blade guard A raised,
remove the hex bolt, Outer flange and blade. (Fig. 21)
To install the blade, mount if carefully onto the spindle making sure that the direction of the arrow on the surface 01 the blade
matches the direction of the arrow on the blade case. Install the outer flange and hex bolt, and then use the socket wrench to
tighten the hex bolt (left handed) securely counterclockwise while pressing the shaft lock.
NOTE:
• When installing a saw blade, be sure to insert it between the blade guard B at first and then raise it so that the blade is finally
placed in the blade guard B. (Fig. 22 & 23)
For all countries other than European countries (Fig. 24)
CAUTION:
•
The silver ring 25.4 mm in outer diameter is factory-installed onto the spindle. The black ring 25 mm in outer diameter is
Included as standard equipment (depending on the model purchased). Before mounting the blade onto the spindle. Always be
sure that the correct ring for the arbor hale of the blade you intend to use is installed onto the spindle.
For European countries
CAUTION:
• The ring 30 mm in outer diameter is factory-installed between the Inner and outer flanges.
Return the lower blade guard A to its original position. Lower the handle to make sure that the lower blade guards move properly.
Make sure shaft lock has released spindle before making cut.
Adjusting riving knife
There must be a clearance of about 5 — 6 mm between the riving knife and the blade teeth when pushing riving knife toward the
blade fully. Adjust the riving knife accordingly by first loosening clamping nut by hand counterclockwise and then loosening hex
bolt counterclockwise with the hex socket wrench, and measuring the distance. After adjustment, securely lighten the hex bolt
and then the clamping nut clockwise. Always check to see that the riving knife is secured and that the top blade guard works
smoothly before cutting. (Fig. 25 & 26)
The riving knife has been installed before shipment from the factory so that the blade and riving knife are in a straight line after
your simple set-up. Refer to the section titled "Repositioning wing knife" for the set-up. (Fig. 27)
CAUTION
•
If the blade and riving knife are not aligned properly, a dangerous pinching condition may result during operation. Make sure the
riving knife is positioned between both outer ends of the blade teeth when viewing from the top. You could suffer serious
personal injury while using the tool without a properly aligned riving knife. If they are not aligned for any reasons. Always have
authorized service center repair it.
•
When adjusting the riving knife clearance from the blade teeth. Always loosen the hex bolt only after loosening the clamping
nut.