BorMann 022299, Руководство пользователя

Страница: 30 / 30

30
www.BormannTools.com
Fault Possible cause Remedy
Diamond cutting disc comes
off when motor is deactivated.
Fastening nut not tightened properly Tighten fastening nu
when motor is deactivated. Failure of mains circuit - breaker Check mains circuit - breaker
Extension cable defective Replace extension cable
Connection with motor or switch is
not OK
Have it checked by an electrician
Motor or switch Is defective Have it checked by an electrician
Motor has no output Cross - section of the extension cable
Is not sufficient
See electrical connection, the fuse has blown
Overloading Check tool
The diamond cutting wheel is dull Replace the diamond cutting wheel with a
new one
The motor switches off during
work
The motor switches off due to over -
loading, e.g. from excessive cutting
depth.
Wait until the motor has cooled down (5 -10
minutes), then switch it on again.
The pump shuts off The pump switches off due to over -
loading, e.g. due to heavy contami -
nation.
Immediately shut down the machine. Clean
the pump and restart the machine after ap -
prox. 5 - 10 minutes. Attention! Never perform
dry cuts!
The cutting process is not
optimal
The cutting wheel is too heavily
stressed
Use a suitable cutting wheel, reduce cutting
pressure
Diamond segments are too dull Sharpen the cutting wheel
The cutting wheel has overheated
due to insufficient cooling water.
Optimise the cooling water supply