BorMann 022299, Руководство пользователя

Страница: 25 / 30

25
www.BormannTools.com
as they are discovered.
•
Do not leave the device running unattended.
Other safety instructions
Please read all the instructions before using this product!
Workplace
To rule out the risk of physical injury, machine damage, fire and electric shock, please ensure that your workplace is protected
•
against humidity, wetness and rain,
•
It is free of Inflammable gases and liquids,
•
It is protected from children – use padlocks and the master switch when the machine is not in use;
•
It is clean and empty,
•
It is well - ventilated and illuminated.
The operators
Healthy commonsense and caution are factors that cannot be integrated in a machine. These factors are the responsibility of the
operator. Please consider the following:
Prevent body contact with grounded surfaces such as pipes and radiators.
Please be watchful. Do not work at the machine if you are tired.
Do not operate the product under the influence of alcohol or drugs. Read the warning instructions to determine whether your
judgement or your reflexes could be affected.
Do not wear loose clothing or ornaments which can get entangled in rotating components.
Anti - skid shoes are recommended. Protect long hair with suitable means.
Wear eye - and ear protection. Always wear:
•
ANSI - approved dust masks.
•
Hearing protection.
Always maintain your balance.
Do not stretch yourself over running machines.
Residual risks
The machine is built according to the latest technology and the recognized technical safety -re lated rules. Nevertheless, individual
residual risks can occur during operation.
•
Danger of Injury to fingers and hands from the running tool if it is used incorrectly.
•
Risk to health from dust. Wear personal protection equipment such as eye protection without fail.
•
Injuries due to defective diamond cutting disc. The diamond cutting disc must be checked regularly for physical integrity.
•
Risk of injury to fingers and hands during cutting disc replacement. Wear appropriate working gloves.
•
Risk of injury during machine activation from sudden start of cutting disc.
•
Risk from power while using improper electric connecting cables.
•
Risk to health from running cutting disc due to long hair and loose clothing. Wear personal protection equipment like hair net
and tight - fitting working clothes.
•
Even after taking all the necessary precautions, not apparent residual risks cannot be ruled out completely.
•
Residual risks can be minimized if the „safety instructions «and the „proper use“, as well as operating instructions manual are
observed jointly.
Before start - up
Replace cracked diamond cutting discs.
•
Get to know your machine. Familiarize yourself with its use and its restrictions, but also with the specific potential risks.
•
Check the machine carefully for damages to ensure that it is able to achieve the intended output. In case of doubt, please
replace the concerned component.
•
Ensure that the switch is off, before inserting the power plug into the mains socket.
•
Ensure that the machine is cleaned and lubricated properly.
•
Before start - up, check the machine for damaged parts and find out whether these parts are working properly and performing
their defined function. Check the alignment of all moving parts, all bro - ken or fastening parts, and all other conditions that
can affect smooth operation. Each damaged part should be repaired or replaced by a technician immediately.
•
Do not use the machine if a switch cannot be activated/deactivated correctly.
Operation
•
Install the machine on an even, slide - proof floor.
•
Check that the voltage on the nameplate matches the existing voltage; connect the power plug to the mains power supply only
thereafter
•
The cutting disc should be free to run before the machine is switched on.
Caution: Cutting disc must always be cooled with water.