Borg & Overström
GB
7
Install & Operation Manual
Also allow for the height
of the tap levers under any
overhanging cupboard/shelf.
Carefully form the needed hole,
using the correct type of cutter
for the work surface material.
Observe all local occupational
health and safety requirements.
Remove the back nut from
the tap and carefully feed the
connecting pipe tails through the
hole formed in the work surface.
Ensure the rubber gasket is
positioned correctly on the base
of the tap.
With the tap in position carefully
refit the nut. Take care not to
over-tighten.
6
10
9
Allow for the space needed
for forming the required hole.
Relate the selected position to
the underneath of the counter
and check for any obstructions.
Allow sufficient space for fitting a
back nut to the faucet stem.
7
70mm
8
11
Fit optional Drip Tray at this
stage (if selected).
12
470mm
