BORETTI BS-45, Инструкция по эксплуатации и обслуживанию

Страница: 7 / 132

Attaching the power supply cable to the mains.
In case of direct connection to the mains, it is necessary to install an omnipolar switch
between the appliance and mains power with a minimum opening between the contacts of
3mm dimensioned for the indicated capacity and in compliance with currently enforced
regulations (the ground cable must not be interrupted by the switch).
The power supply cable must be positioned in a way that it does not exceed 50°C in any area
of the surrounding temperature.
The installer is responsible for correct electrical hook-up and adherence to safety regulations.
Before hook-up to the mains, make sure that:
-
the socket has a ground connection and that it complies with legal regulations;
- the socket is able to withstand the oven's maximum power capacity indicated on the
features plate.
- the power supply voltage is within the value80s listed in the electrical characteristics
label.
-
the socket is compatible with the appliance plug.
-
If this is not the case, replace the socket or the plug. Do not use extension cords or
multiple sockets.
-
Once the appliance is installed, the electrical cable and the electrical power socket must
be easy to reach.
- The cable must not be bent or compressed.
-
The cable must be periodically checked and only replaced by authorized technicians.
-
The Company declines any responsibility if these instructions are not adhered to.
Replacement of the power cable:
If the power cable needs to be replaced, use cables of the following type only:
- H05 RR-F,
-
H05 V2V2-F (T90),
suitable for the operating capacity and temperature.
The green-yellow ground cable must be longer than the other two conductors
by approximately 2cm.
7