bora CKASE, Руководство по эксплуатации

Страница: 18 / 32

EN
18
Installation
www.bora.com
1
2
3
Abb. 6.17 Shortening the silence module
[1] Silence module
[2] Cut marks
[3] Fine saw
X X
Now place the (curved or straight) transition piece and
the silence module together on the plinth fan.
2
3
5
4
1
Abb. 6.18 Assembly
[1] Protective grid
[2] Silence module
[3] Transition piece (curved or straight)
[4] Universal plinth fan inlet nozzle
[5] Universal plinth fan
X X
Saw out the necessary cut-outs for the ducting in the
rear panel of the floor unit.
X X
Depending on the installation situation, adjust the
levelling feet on the floor unit as necessary.
X X
Now adapt the substructure module to the available
depth of the worktop by shortening the substructure
module at the cut marks using a fine saw.
1
2
Abb. 6.16 Securing the cooktop extractor
[1]
Tensioning screw
[2] Clamp
X X
Turn the four clamps [2] under the worktop.
X X
Tighten the clamp screws [1] with max. 10 Nm.
X X
Check that the cooktop extractor frame is positioned
correctly.
X X
Once all of the installation work is complete, seal the
devices with black, heat-resistant silicone sealant.
6.5.2 Preparing to install the substructure
module, silence module and plinth fan
INFO The floor unit must not be supported on the
plinth fan housing.
INFO For correct installation, the slide-in units of the
base cabinet must be shortened depending on
the installation situation.
INFO The plinth fan must only be installed
horizontally.
X X
Now adapt the cooktop extractor system to the
worktop height by shortening the silence module at the
cut marks using a fine saw.