6
10
11
9
Aileron Servo installation
Outer wing panel
Centre Wing
When cutting away the film,for
the servo mount leave a gener-
ous overhang to allow for the
strong shrinkage of the Profilm
(Orocover) when you finally iron
it back in place.
A
B
Assemble left and right sides
the same way.
Assemble left and right sides
the same way.
Be sure to apply instant type CA glue to
both sides of each hinges.
(low viscosity type)
Cut away covering film.
Warning!
2.6 x12mm TP Screw
Be sure to glue securely.
This is Vital for safe flying!
11
23
22
For Retractable landing gear.
Noseleg Servo
Noseleg Mounting
“Trim the Cover Plate to clear the leg.”
8
2.6 x12mm TP Screw
2
2 x 100mm
Pushrod
2
Clevis
The nose leg length adjusted to give a
degree or two negative incidence or slightly
nose down attitude when Intro is standing on
a level surface. This will be easily overcome
on take off by the elevator authority and will
also help to eliminate bounce on landing.
2
2
4
2
3 x 50mm Bolt
3mm Nut
3mm Washer
3mm Horn
3mm
3mm Nut
3mm Washer
3mm Horn
3 x 50mm Bolt
3mm
Apply thin cyano top and bottom and
immediately tighten the 3mm. nut to
prevent the 3mm. bolt rotating.
2
Aluminium joiner
6 x 40mm
Aluminium joiners
6 x 40mm
Not Supplied.
Not Supplied.
2mm
Not Supplied.
4
2.6 x12mm TP Screw
2.6 x12mm TP Screw
2
Cut away part of the former at the
rear of the rails to allow the retract
unit steering arms to drop cleanly aft
of the retract mounting rails.
