Page 7
BONNET CIDELCEM GRANDE CUISINE
Siége social:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
2.5 ASSEMBLY ONTO A SINGLE UNDERFRAME
Place appliance on the underframe, with rear of
appliance and the underframe approximately aligned. (The
underframe is symmetric front and rear are identical).
Push the unit backwards until the hooks in the base
locate into the 25mm square holes provided
Repeat these two operations for each appliance to be fitted
on the same underframe.
Fix the front to the underframe with HM 5 x 16mm nuts
and bolts + 2 washers either inside when the appliance
design makes this possible (cupboard) or from underneath.
Connect the units to each other:
1) at the rear inside the vent again with 5 x 16mm
fixings irrespective of the type of equipment.
2) at front inside the facia after removing the front of the
appliance (see section).
- Use HM5 x 16mm bolts + 5mm Ø washers for
boiling pan or deep fat fryer connected to
cooking unit (a captive nut is located in the side
rails behind the facia).
- Use HM5 x 16mm nuts and bolts + 5mm Ø
washer to connect cooking units together,
having removed the M5 captive nut from one of
the 2 appliances (from the screw side), using a
screwdriver.
