Page 5
BONNET CIDELCEM GRANDE CUISINE
Siége social:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
2. INSTALLATION: GENERAL FEATURES
TYPE AND POSITION OF CONNECTIONS
See "Technical data" at the beginning of these instructions.
2.1 GENERAL REQUIREMENTS
The installation or repair of this appliance should be carried out according to current regulations by
a qualified engineer.
These appliances are intended for professional use, they must only be used by trained personnel.
The appliance must be installed in compliance with the appropriate standards, in an adequately
ventilated area.
These appliances should ideally be against a wall. The latter must be of non-combustible materials
or, if not, should be covered with an appropriate material, good insulator, non-combustible.
2.2 HANDLING
The appliance should be handled with specialised lifting equipment only.
If the appliance is to be transported, this must be done on its original pallet and it must not be stacked
in any circumstance.
If the appliance is to be moved without its pallet, it should be carried and not dragged.
2.3 UNPACKING
Before installation, remove the strapping. The individual parts are not bolted down.
Remove plastic coating from stainless steel before heating the appliance.
2.4 ACCESS TO COMPONENTS BEHIND THE FRONT PANEL
a) Removing the facia
- Slacken the control knobs fixing
screws.
- Remove electrical and water inlet
control knobs.
