BONFIGLIOLI TECNOINGRANAGGI LC Series, Инструкция по установке, использованию и обслуживанию

Страница: 23 / 64

8 USING THE EQUIPMENT
Before putting the gear unit into service, the User must ensure that the plant in which it is installed
complies with all applicable directives, especially those regarding health and safety at work.
The gear unit may not be used in areas and environments:
with highly corrosive and/or abrasive vapours, smoke or dust
in direct contact with loose food products.
Danger zones and exposed persons:
The danger zone of the gear unit is the protrusion of the shaft which constitutes a hazard for
exposed persons in direct contact with it (crushing, cutting, trapping). In particular, when the
gear unit is operating in automatic mode and in an accessible area, the shaft must be protected
by a guard.
9 MAINTENANCE
9.1 MAINTENANCE
Before doing any work on the unit, the operator must first switch off power to the gear
unit and ensure that it is out of service, as well as taking all necessary precautions
against it being accidentally switched on again or its parts moving without warning (due
to suspended loads or similar external factors).
Furthermore, all additional environmental safety precautions must be taken (e.g.
elimination of residual gas or dust, etc.).
Before doing any maintenance work, activate all safety equipment and, if necessary, inform
persons working in the vicinity. In particular, mark off the area around the unit and prevent
access to any equipment which, if activated, might be the cause of unexpected health and
safety hazards.
The Manufacturer declines all liability for injury and damage to components due to the use of non-
original spare parts and non-routine work which modifies the safety requirements without the express
prior authorisation of the Manufacturer.
Refer to the specific spare parts catalogue when ordering spare parts for the gear unit.
Do not dump polluting liquids, worn parts and maintenance waste into the environment.
Dispose of all such materials as stipulated by applicable legislation.
9.2 ROUTINE MAINTENANCE
Service program to be conducted when commissioning the gear unit and thenafter at 500 hours
interval:
Check that noise at constant load does not vary. Excessive vibration or noise can indicate wear
of the gear train or failure of a bearing.
Check for lubricant leaks from the gaskets/seals.
Check the torque that the locking bolt of the input coupling is tightened at. Refer to values
specified in the relevant section of this Manual.
Check that all bolts securing the gear unit to the machine are tightened firmly. Refer to
tightening torque values specified in this Manual.
Clean all dust and process waste off the gear unit. Do not use solvents or other products which
are incompatible with the construction material and do not direct high-pressure jets of water at
the gear unit.
21