Bonex aquaProp, Инструкция по эксплуатации

Страница: 8 / 19

aquaProp–SCOOTER
Instruction for use
Version : SG 2015-11 Page | 8
8. Starting up
The aquaProp scooter is prepared ready for use to the customer before delivery. However, the battery needs to be
charged again before it is connected.
The scooter is subjected to a function test after completion.
Before first use, please refer to the scooter from the shipping container
Please keep the shipping materials for further use (maintenance or repair)!
Open the scooter by turning the housing upper part of the system handle to the mark "OPEN". Place the scooter with
the propeller nozzle on a flat surface and turn the housing upper part of the system handle. Hold it firmly to the lower
housing part.
Hold the housing top with both hands and pull it in the "OPEN" position to the top.
Scooter open Scooter closed
8.1 Controls to perform before starting
Make sure that all parts are tight and there are no loose parts in the scooter around may fall. Make a visual check,
that all cable plugs firmly and the cables are not damaged.
Grease the seal rings and the inner tube edge lightly with
silicone grease. Check the tightness of the battery pack and connect the battery connector at the motor connector.
Immediately after connecting a sound signals. Now place the upper housing to the lower part in the desired position
(1-hand / 2-hand) with the arrow on "OPEN". Press the upper housing down, until it stops and turn it to the system
handle to the red arrow "CLOSE".
Make sure that when you touch down, no cables are pinched!
If the process does not work as described, please contact any force, but once again check each step!
Upon delivery, the scooter is trimmed for freshwater. If additional items are attach to the scooter, it may be
necessary, to re-trim. Also trim the scooter again, before use in salt water. Where you insert the battery cover, add
lead plates under the intended screw. Depending on the water content of salt, 1 to max. 3 lead plates are used.
The aquaProp scooter is now ready for use.
To check the correct function, place the scooter on a flat surface and secure it against accidentally rolling away.
After turning on the step switch to position "1" or "2", the scooter is ready for operation. By pressing the drive switch,
the propeller is turning – slow at "Level 1" and quickly at "Level 2". When you release the driving switch, stopps the
propeller.
The scooter was hereby checked again and now is ready to drive. Set the step switch back to "off".
If anything goes
wrong during the test, use the information in the chapter "Error! Reference source not found."!