Bonex aquaProp, Инструкция по эксплуатации

Страница: 11 / 19

aquaProp–SCOOTER
Instruction for use
Version : SG 2015-11 Page | 11
12. Charging the NiMH battery
Only use the aquaProp-Scooter charger to charge the battery!
Always remove the upper housing part during charging!
We recommend, that upon receipt of the aquaProb scooter set, to load the scooter.
Wait after the use of the aquaProp 2 hours before you start charging.
Same time remove the battery connector from the motor connector on the plug-in system.
Connect first the battery with the charger, than with the mains. The LED on the charger is red during charging, after
charging is completed green.
If the LED lights alternately red / green, the battery is fully charged and the charger
maintains the voltage. A yellow LED means, the battery isn’t connected. Flashing indicates a problem and the
process is to repeat. If the problem persists, the device should be returned to the manufacturer.
The connection can be operated in Europe on 230V power, or in some models in U.S. or Latin American countries
with 110V. This may lead to an extension of the loading times.
In order to achieve the optimum battery charging capacity, we recommend recharging.
Do not cover while charging the scooter and provide enough cooling, and avoid heat accumulation !
The chargers are used exclusively for charging nickel-metal hydride batteries!
No sealed lead acid and no Lio batteries can be charged with this charger!
Monitor the loading process!
With intense warming the battery, stop charging immediately and contact the manufacturer!
You will find the user manual of the NiMh charger on the following 3 pages.
0
10
20
30
40
50
8,0
9,0
10,0
11,0
12,0
13,0
14,0
15,0
16,0
17,0
18,0
0 5 10 15 20 25 30 35 40 45 50 55
m/min
V
min
Aquaprop - discharchging Step 2
Voltage in V Speed in m/min