34
replenished after a thorough cleaning. We recommend 303 High Tech Fabric Guard™ as the
preferred retreatment product for Sunbrella fabrics. Fabrics should be retreated after thorough
cleaning or after five years of use. 303 should be applied to Sunbrella fabrics after each
thorough cleaning, which typically removes the original fluorocarbon finish and reduces the
fabric’s water repellency. After cleaning the fabric, allow it to air dry completely and then apply
303 in a thin, even coat. After allowing the first coat of 303 to air dry, apply a second thin, even
coating of 303. Two light coatings are more effective in restoring fabric water resistance than a
single heavy coating. A 15-ounce bottle provides coverage of up to 50 square feet of lightweight
fabric. Always apply 303 to clean fabric.
Zippers and Snaps
Zippers and snaps will loosen with use. Use care when starting the zipper to prevent damage.
Lubricate the snap buttons and zippers with petroleum jelly or paraffin. Fasteners should be
unsnapped as close to the button as possible. We recommend using “Snap-Stick” on all snaps
to prevent corrosion.
Vinyl Windows
Clean clear vinyl thoroughly with denatured alcohol and then apply a protective layer of clear
wax. DO NOT USE PASTE WAX – IT WILL TURN THE VINYL YELLOW. This process should
be repeated as necessary to maintain the protective wax coating. Remove vinyl panels and
store indoors in a climate controlled environment. This will keep the vinyl from cracking. NEVER
FOLD THESE PIECES!
Upholstery
Your exterior vinyl upholstery may be cleaned with a mild solution of household detergent and
fresh water. Commercial cleaners for vinyl also work well. Since the seams of your exterior
upholstery are not waterproof, your upholstery should be stored in a dry location or covered
when not in use.
Hardware Mounting
When drilling holes for mounting hardware in boat surfaces make sure each hole is sealed
properly. Sealing will reduce the risk of water leakage but may not prevent it. All holes can result
in water intrusion and, depending upon placement, may not be evacuated from the boat.
Caulking/Gaskets
Deck fittings, bow rails, windows, hatches and similar items on your boat are caulked into place
to create a water-resistant joint with the boat. However, the working action of normal use will
flex the joint and eventually break down the seal. Periodically inspect the caulking for leaks and
re-caulk as necessary.
Stainless Steel
When stainless steel items on your boat rust, that’s’ your fault. It is caused by a lack of
maintenance. Stainless steel needs regular cleaning to maintain its “less staining” properties.
The key to maintaining stainless steel is to keep it clean with a mild solution of soap and fresh
water. Remove salt or dirt from all metalwork after each use and on a regular basis. If corrosion
begins, use a Scotch® bright pad and Woody’s Wax® to remove it. Cleaning the stainless steel
should be a part of your monthly maintenance routine.
Paint, Anodized, Powder Coat and Similar Coatings
Содержание Bohemian 17
Страница 1: ...1 OWNERS AND OPERATORS MANUAL...
