24
in
/60.9cm
24 po
/6
0.9
PRECAUTIONS
APPLIANCE STAND AND LOCATION
·
Installation and services should only be
made by a qualified person.
·
Do not use the heater in an exposive
atmosphere.
·
Before operation,inspect the hose for
damage.
·
Disconnect LPG cylinder before moving the
heater.
·
Do not attempt to alter any parts of heater.
Example:Using the heater without reflector or
protection guard.
·
The appliance shall not be used in
basements or below ground level.
·
It must always be placed on a solid and level
surface.
·
Never substitute the regulator.Use only one
that is suitable for both appliance category and
normal pressure of gas.
·
Do not clean the heater with cleaners that
are combustible or corrosive.
·
Do not paint protection guard,control box or
reflector.
·
The LPG gas cylinder valve should be
turned off when the heater is not in use.
·
Do not use the heater when it is raining,and
do not let any liquid splash on to the glass tube
when the heater is in use.
·
Keep children away from the heater,always
be careful not to knock over the heater which
will break the glass tube and might cause
injury.
·
Do not move the appliance when in
operation.
·
After a long break in operation,the gas parts
in the control box of the heater and the hose
should be inspected for spiders, spider webs or
other insects.
·
Check the heater immediately if any of the
following exists:
1.There is smell of gas.
2.The heater is not effective enough.
3.The burner makes popping noise during
use(a slight popping noise is normal when the
burner is extinguished after use).
·
The hose with regulator assembly should be
stored in a safe place to avoid accidental
damage.
·
Children and adults should be aware of the
high
surface temperature hazard,and should
keep
a safe distance away to avoid clothes
burni
ng or igniting.
·
Young children should be carefully supervised
when they are in the working area of the heater.
·
Clothing or other flammable material should
not be hung from the heater,or placed on or
near the heater.
·
Do not obstruct the flow of combustion
products.
·
Keep the ventilation opening of the cylinder
enclosure free and clear of debris.
·
Do not obstruct the ventilation holes of the
cylinder housing.
·
Shut off the valve to the gas cylinder or the
regulator before moving the appliance.
·
The tubing or the flexible hose must be
changed within the prescribed intervals.
·
Use only the type of gas and the type of
cylinder specified by the manufacturer.
·
In case of violent wind,particular attention
must be taken against tilting or falling over of the
appliance.The manufacturer is not responsible
for any damage caused by bad weather.
4
24 in /60.9 cm and
sides 24 in /60.9 cm.
24
in
/60.9cm
