- 14 -
5-E: Power Cord / Power Connection
Always make sure that the power switch is set to the OFF position before performing the
following tasks:
o
Plug the detachable AC cord into the back of the unit.
o
Plug the 3-prong plug into a grounded outlet.
Safety Instructions
A. Grounding:
Prior to connecting accessories to the unit, check that the main unit is plugged into a
grounded wall outlet.
B. Main voltage range and fuse:
Prior to plugging the AC adapter into the power outlet, check that the voltage is supported.
5-F: Foot Control Cable Assembly Connection
Align the pins of the foot control plug with the receptacle on the back of the device and push in
until the plug is firmly seated.
5-G: Water Supply Line Connection
Push the blue water tube (hose) into the stainless steel receptacle until the hose cannot be pushed
any further. Then tighten the screw.
Connect the quick connect to the water supply line. The KRUUSE-SP1 should be prepackaged
with a male quick connect. If a female quick connect is necessary, please contact a Bonart
distributor to purchase it.
Inspect all connections for leaks.
To remove the water line from the KRUUSE-SP1 scaler, first, turn off the water supply or
disconnect the water supply line. Then loosen the screw on the water tube from the receptacle of
the unit and gently pull the water hose out.
5-H: Hand piece Cable Assembly Connection
The KRUUSE-SP1 scaling hand piece is designed only for inserts with a frequency of 25khz. The
KRUUSE-SP1 is no long available in 30khz so please do not try using a 30khz insert with the
KRUUSE-SP1.
