17
SCORPION User Manual_
February 2013 Edition
Abrasive assembly procedures
Scorpion Expansion (centrifugal drum)
Fit the abrasive disc (pos. 2 fig. C) to the drum (pos.1)
ensuring that the abrasive protrudes approximately 1.5 mm
from the drum itself.
BEWARE
Do not start the machine without the
abrasive inserted,
otherwise the drum will be damaged and
must be replaced.
WARNING
The abrasive is in the correct position when it protrudes approximately 1.5 mm
from the sander drum.
HAZARD
Using a damaged abrasive which could then tear while sanding may damage the
machine or floor.
Scorpion EasyFit (drum with bubble mat surface)
Loosen the fastening screws (
pos.
1 fig. D
) on the paper press (
pos.
2 fig. D
) on the drum with the correct
screwdriver, being careful not to remove the screws and paper press from the drum
.
Insert one end of the abrasive (
pos. 3 fig. D
) under the paper press. Turn the drum so the abrasive winds around
the drum itself. Insert the other end (
pos. 4 fig. D
) of the abrasive under the paper press. Centre the abrasive on
the drum and smooth out any creases. Tighten the paper press screws carefully. If unsure loosen the paper press
screws and repeat the procedure.
HAZARD
An abrasive which is not stretched correctly or is damaged could tear while
sanding and damage the machine or floor.
Содержание Scorpion
Страница 1: ...1 Scorpion by Owner Operation Manual ...
Страница 25: ...25 SCORPION User Manual_February 2013 Edition Diagrams ...
Страница 26: ...26 SCORPION User Manual_February 2013 Edition Diagrams ...
Страница 28: ...28 February 2013 Edition ...
