Section 03
ENGINE
Subsection 09
(CRANKSHAFT)
VMR2003_013_03_09A.FM
03-09-3
GENERAL
For installation, use the torque values and Loctite
products from the exploded views. Clean threads
before using Loctite when installing the screws.
CRANKSHAFT LOCKING
PROCEDURE
Removal
Unplug spark plug cable then remove the spark
plug.
Remove:
– RH footwell
– valve cover and breather
(refer to
CYLINDER AND HEAD
)
– magneto cover (refer to
MAGNETO SYSTEM
)
– screw
no. 3
and shim
no. 4
.
1. Screw
2. Copper shim
Turn rotor, fixed on crankshaft MAG side, to TDC
compression position (refer to
CYLINDER AND
HEAD
).
Use a screwdriver to check if groove in crankshaft
is aligned with the hole.
1. Screwdriver
Lock crankshaft with crankshaft locking bolt (P/N 529
035 617).
1. Crankshaft locking bolt
2. Hole in the area of electrical starter
WARNING
Torque wrench tightening specifications
must strictly be adhered to.
Locking devices (ex.: locking tabs, elastic stop
nuts, self-locking fasteners, etc.) must be in-
stalled or replaced with new ones where
specified. If the efficiency of a locking device
is impaired, it must be renewed.
1
R175motr04A
2
R175motr05A
1
1
R175motr06A
2
Содержание RALLY 200 2003
Страница 1: ......
Страница 2: ...2003 Shop Manual RALLY 200 ...
Страница 189: ...Section 04 FUEL SYSTEM Subsection 03 CARBURETOR VMR2003_017_04_03A FM 04 03 1 CARBURETOR 0 V06F0BS 2 4 5 1 7 3 6 ...
Страница 273: ...Section 10 BODY FRAME Subsection 03 FRAME VMR2003 030_10_03A FM 10 03 1 FRAME 0 V06L0KS 1 4 3 2 10 N m 89 lbf in ...