BOMBARDIER RALLY 200 2003, Руководство по ремонту

Страница: 271 / 282

Section 10 BODY/FRAME
Subsection 02 (BODY)
10-02-6
VMR2003_029_10_02A.FM
Installation
Installation is the reverse order of removal.
NOTE: Install all screws before torque.
SEAT COVER REPLACEMENT
Remove the old seat cover. Check the foam and
replace if necessary.
Install staples with an electric tacker such as Arrow
tacker no. ETN-50 or with a manual tacker such as
Arrow tacker no. T-50.
NOTE: For an easier installation, it’s highly recom-
mended to use an electric tacker.
Ensure that the seat rest firmly against a hard sur-
face such as a piece of wood. This is done to get
the staples completely pushed in place.
TYPICAL
1. Piece of wood
2. ETN-50 (electric) or T-50 (manual)
After cover installation cut all around the excess of
material.
SEAT CLEANING
It is recommended to clean the seat with a solution
of
warm soapy water , using a soft clean cloth.
CAUTION: Avoid use of harsh detergents such
as strong soaps, degreasing solvents, abrasive
cleaners, paint thinners, etc. that may cause dam-
age to the seat cover.
DECALS REPLACEMENT
Removal
Using a heat gun warm up one end of decal for a
few seconds until decal can roll off when rubbing
with your finger.
Pull decal slowly and when necessary apply more
heat to ease removal on the area that has to be
peeled off.
If decal tears while pulling off, it has to be heated
for a few seconds longer. If decal tends to stretch
while pulling off, stop heating and wait a few sec-
onds to let it cool, then peel it off.
Installation
There are 2 types of decals used on ATV. One has
a protective film on back side and the other has a
protective film on both sides. They are used on 2
types of materials; plastic and metal.
DECALS HAVING A PROTECTIVE FILM ON
BACK SIDE ONLY
These decals usually contain written information
(ex.: warning).
Clean surface with a good solvent such as ACRYL-
ICLEAN DX 330 from PPG or equivalent (refer to
manufacturer instructions).
Using a pencil and the decal as a template, mark
the area where decal will be located.
Remove half of the decal back protective film and
align decal with marks. Start sticking it from center
and remove the other half of the film to stick it
completely. Carefully squeegee decal beginning at
center and working outward using, firm, short,
overlapping strokes.
F01L3YA
2
1