Loosen the screw (1) for approx. five turns and pull the oil
filter (2) out of the housing.
CAUTION!
Danger of eye injuries caused by particles
flying around!
–
Wear your personal protective equipment
(safety gloves, protective working clothes,
goggles).
Blow the oil filter out from inside to outside.
Check the seal (2) for damage, change if necessary.
Slightly oil the seal rings (1) and (2).
Insert the oil filter (2) into the housing and press it against the
end stop.
Before tightening the screw (1) make sure that the tensioning
springs touch the oil filter with both ends.
Tighten the screw.
Fill in fresh engine oil up to the bottom edge of the filling
opening.
After a short test run check the oil level on the dipstick, if nec-
essary top up to the top dipstick mark.
Cleaning the oil filter
Fig. 60
Fig. 61
Fig. 62
Filling in engine oil
Fig. 63
Maintenance – Annual maintenance
BPR 50/55 D / BPR 60/65 D
69
Go
to
Discount-Equipment.com
to
order
your
parts
